Search results
Results From The WOW.Com Content Network
Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:
The Schrader valve is used on virtually all automobile tires and motorcycle tires and most wider-rimmed bicycle tires.In addition to tube and tubeless tires, Schrader valves of varying diameters are used on many refrigeration and air conditioning systems to allow servicing, including recharging with refrigerant; by plumbers conducting leak-down pressure tests on pipe installations; as a ...
Some such pumps are designed to cut off before a suitable pressure (much higher for a bicycle than a car tire), and will much under inflate the tire. Others may not cut off, but deliver a high rate of flow to fill the larger car tire, with a risk of over inflating and bursting a bicycle tire unless it is stopped with split-second timing.
For low inflation pressures, this distinction is more important, as the ideal gas law applies to absolute pressure, including atmospheric pressure. For example, if a fat-bike tire is inflated to 0.5 bar (50 kPa; 7.3 psi) gauge pressure at room temperature 20 °C (68 °F) and then the temperature is decreased to −10 °C (14 °F) (a 9% decrease ...
The problem with this method was that if tires all lost the same pressure then none would show up against the others to indicate a problem. However, research has shown that both direct and indirect tire pressure monitoring systems are equally effective. [1] Tire-pressure gauges measure air pressure using various methods:
The Presta valve (also French valve (FV) or Sclaverand valve) is a type of tire valve commonly found on high pressure bicycle inner tubes and is commonly used on tubeless setups. It consists of an outer valve stem and an inner valve body. A lock nut to secure the stem at the wheel rim and a valve cap may also be present.
Colorized tire footprint pressure distribution. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface.It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire's tread that touches the road surface.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.