Search results
Results From The WOW.Com Content Network
Goldschmidt's tolerance factor (from the German word Toleranzfaktor) is an indicator for the stability and distortion of crystal structures. [1] It was originally only used to describe the perovskite ABO 3 structure, but now tolerance factors are also used for ilmenite.
In a toxicity test, the NOEC and LOEC are derived as a comparison from the negative control, or the experimental group that does not contain the chemical in question.The NOEC is the highest concentration that does not cause a statistically different effect than the negative control through statistical hypothesis testing.
Consider , the exact solution to a differential equation in an appropriate normed space (, | | | |). Consider a numerical approximation u h {\displaystyle u_{h}} , where h {\displaystyle h} is a parameter characterizing the approximation, such as the step size in a finite difference scheme or the diameter of the cells in a finite element method .
Tolerable daily intake (TDI) refers to the daily amount of a chemical contaminant that has been assessed safe for human being exposure on long-term basis (usually whole lifetime). [1] TDI specifically occurs to chemicals that humans are exposed to unintentionally or as a contaminant, [ 1 ] where acceptable daily intake refers to chemicals that ...
The process also allows for opportunities at each step for the TLV to be withdrawn from consideration due to lack of available data or other reasons. The process adheres to the following steps: Substance Under Study: When a substance or agent has been proposed for a new or updated TLV or BEI, it is placed under a list of possible candidates in ...
An error-tolerant design (or human-error-tolerant design [1]) is one that does not unduly penalize user or human errors. It is the human equivalent of fault tolerant design that allows equipment to continue functioning in the presence of hardware faults, such as a "limp-in" mode for an automobile electronics unit that would be employed if ...
The table shown on the right can be used in a two-sample t-test to estimate the sample sizes of an experimental group and a control group that are of equal size, that is, the total number of individuals in the trial is twice that of the number given, and the desired significance level is 0.05. [4]
Because the RfD assumes "a dose below which no adverse noncarcinogenic health effects should result from a lifetime of exposure", [5] the critical step in all chemical risk and regulatory threshold calculations is dependent upon a properly derived dose at which no observed adverse effects (NOAEL) were seen which is then divided by an ...