Search results
Results From The WOW.Com Content Network
Dynamic range (abbreviated DR, DNR, [1] or DYR [2]) is the ratio between the largest and smallest measurable values of a specific quantity. It is often used in the context of signals , like sound and light .
Measurement of a target's RCS is performed at a radar reflectivity range or scattering range. [citation needed] The first type of range is an outdoor range where the target is positioned on a specially shaped low RCS pylon some distance down-range from the transmitters. Such a range eliminates the need for placing radar absorbers behind the ...
[84] [85] The echo power is measured in terms of radar cross-section, , , or (total power, SC + OC) and is equal to the cross-sectional area of a metallic sphere (perfect reflector) at the same distance as the target that would return the same echo power.
Range and velocity can both be identified using medium PRF, but neither one can be identified directly. Medium PRF is from 3 kHz to 30 kHz, which corresponds with radar range from 5 km to 50 km. This is the ambiguous range, which is much smaller than the maximum range. Range ambiguity resolution is used to determine true range in medium PRF radar.
The path of this projectile launched from a height y 0 has a range d. In physics, a projectile launched with specific initial conditions will have a range. It may be more predictable assuming a flat Earth with a uniform gravity field, and no air resistance. The horizontal ranges of a projectile are equal for two complementary angles of ...
In telecommunications and transmission line theory, the reflection coefficient is the ratio of the complex amplitude of the reflected wave to that of the incident wave. The voltage and current at any point along a transmission line can always be resolved into forward and reflected traveling waves given a specified reference impedance Z 0.
In comparison to a distinct echo, that is detectable at a minimum of 50 to 100 ms after the previous sound, reverberation is the occurrence of reflections that arrive in a sequence of less than approximately 50 ms. As time passes, the amplitude of the reflections gradually reduces to non-noticeable levels.
The SNR values are given for the rectangular region on the forehead. The plots at the bottom show the signal intensity in the indicated row of the image (red: original signal, blue: with noise). Signal-to-noise ratio ( SNR or S/N ) is a measure used in science and engineering that compares the level of a desired signal to the level of ...