Ad
related to: jib crane footing chart diagram design pdf
Search results
Results From The WOW.Com Content Network
A level-luffing crane is a crane mechanism where the hook remains at the same level while luffing: moving the jib up and down, so as to move the hook inwards and outwards relative to the base. [ 1 ] Usually the description is only applied to those with a luffing jib that have some additional mechanism applied to keep the hook level when luffing.
This specific example uses a level luffing mechanism to maintain the load at approximately the same vertical height as the jib moves through its range of travel. A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. [1] [2] An archaic spelling is gib. [3]
In the mid-1880s, a further development of the crane design took place, the Hercules crane. A crane was needed which could set larger and heavier blocks, up to 30 tons. The Hercules design combined aspects of the Manora and the Port Alfred cranes. A horizontal jib was used, with the ability to slew sideways.
The "hammerhead", or giant cantilever, crane is a fixed-jib crane consisting of a steel-braced tower on which revolves a large, horizontal, double cantilever; the forward part of this cantilever or jib carries the lifting trolley, the jib is extended backwards in order to form a support for the machinery and counterbalancing weight. In addition ...
The Hercules design combined aspects of both the earlier fixed-jib gantry cranes built for works at Manora and that would later be used for a slewing jib crane at Port Alfred. A horizontal jib was added, with the ability to slew sideways. A horizontal non-luffing jib [i] was used, separate from the lower frame. This was supported on two ...
Knuckle boom crane arms are much lighter than boom truck cranes, and they are designed to allow for more payloads to be carried on the back of the truck that it is mounted on. The majority of them are mounted behind the cab and leave the entire bed of the truck empty.
Power shovels normally consist of a revolving deck with a power plant, drive and control mechanisms, usually a counterweight, and a front attachment, such as a crane ("boom") which supports a handle ("dipper" or "dipper stick") with a digger ("bucket") at the end. The term "dipper" is also sometimes used to refer to the handle and digger combined.
BREM-80U (BREM-80) – Armoured recovery vehicle (ARV) based on the T-80U, with a large superstructure on the forward half of the chassis, a large square-section 18-tonne crane on the left side of hull and 35-tonne winch (in contrast to earlier Soviet ARVs which had light jib cranes). [6] BTU-80 – Dozer vehicle based on T-80. [6]