When.com Web Search

  1. Ads

    related to: anchor point piton

Search results

  1. Results From The WOW.Com Content Network
  2. Anchor (climbing) - Wikipedia

    en.wikipedia.org/wiki/Anchor_(climbing)

    A load-sharing (or load-distributing) anchor is a system consisting of two or more individual anchors which join together at a main anchor point to form an anchoring system. This configuration is a way to introduce redundancy and increase strength, typically for a belay anchor.

  3. Piton - Wikipedia

    en.wikipedia.org/wiki/Piton

    1960s-era pitons, including: knifeblades, lost arrows, bugaboos, ring angles, and bongs. A piton (/ ˈ p iː t ɒ n /; also called pin or peg) in big wall climbing and in aid climbing is a metal spike (usually steel) that is driven into a crack or seam in the climbing surface using a climbing hammer, and which acts as an anchor for protecting the climber from falling or to assist progress in ...

  4. Glossary of climbing terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_climbing_terms

    A type of anchor used in soft rock instead of bolts that uses a "baby angle" (piton) hammered into a drilled hole, which some think is better in soft rock than bolts that can crack the rock. [41] [42] drive-by A deadpoint where one arm crosses over the other to reach a hold that is above and to the side. drop knee. Also egyptian. Also knee drop ...

  5. Ice screw - Wikipedia

    en.wikipedia.org/wiki/Ice_screw

    An ice screw. Some modern screws like this one now have a handle to assist entry and removal, whereas early models did not. An ice screw is a threaded tubular screw used as a running belay or anchor by climbers on steep ice surface such as steep waterfall ice or alpine ice during ice climbing or crevasse rescue, to hold the climber in the event of a fall, and at belays as anchor points.

  6. Top rope climbing - Wikipedia

    en.wikipedia.org/wiki/Top_rope_climbing

    Top roping requires a fixed anchor at the top of the climb, from which two sides of the rope can be hung back down to the base. Because top roping is either done by novice climbers, or by experienced climbers practicing to attempt a route at the limit of their capabilities, there is a high probability that the anchor will experience a load, and ...

  7. Belaying - Wikipedia

    en.wikipedia.org/wiki/Belaying

    The anchor point does not prevent a fall, but prevents the belayer from being pulled upwards during a fall. [4] This is normally not used when lead belaying. [5] To set up this anchor the belayer should place a piece of directional protection (i.e., a nut or cam) into a crack below their body, or tie themselves by the belay loop to a rock or tree.

  8. Who are the American hostages being released in the Israel ...

    www.aol.com/details-revealed-hostages-being...

    Marking an end to more than 15 months of deadly conflict, Israel and Hamas reached a ceasefire deal on Wednesday that includes the release of captives held by both parties. The agreement was ...

  9. Self-locking device - Wikipedia

    en.wikipedia.org/wiki/Self-locking_device

    Knowledge of the correct device position relative to the rope anchor is critical for the correct operation of the cam devices in a fall as they are mono-directional in operation, and the soloer must be aware that he needs to put in a runner as soon as he sets off above the belay point on a multi-pitch climb, otherwise he can slide to the bottom ...