Search results
Results From The WOW.Com Content Network
Tempering can further decrease the hardness, increasing the ductility to a point more like annealed steel. [8] Tempering is often used on carbon steels, producing much the same results. The process, called "normalize and temper", is used frequently on steels such as 1045 carbon steel, or most other steels containing 0.35 to 0.55% carbon.
Tempering consists of heating steel below the lower critical temperature, (often from 400˚F to 1105˚F or 205˚C to 595˚C, depending on the desired results), to impart some toughness. Higher tempering temperatures (maybe up to 1,300˚F or 700˚C, depending on the alloy and application) are sometimes used to impart further ductility, although ...
as when a man who works as a blacksmith plunges a screaming great axe blade or adze into cold water, treating it for temper, since this is the way steel is made strong, even so Cyclops' eye sizzled about the beam of the olive. However, it is not beyond doubt that the passage describes deliberate quench-hardening, rather than simply cooling. [8]
Normalization is an annealing process applied to ferrous alloys to give the material a uniform fine-grained structure and to avoid excess softening in steel. It involves heating the steel to 20–50 °C above its upper critical point, soaking it for a short period at that temperature and then allowing it to cool in air.
Differential tempering begins by taking steel that has been uniformly quenched and hardened, and then heating it in localized areas to reduce the hardness. The process is often used in blacksmithing for tempering cutting instruments, softening the back, shaft, or spine, but simultaneously tempering the edge to a very high hardness. The process ...
The process quenches the surface layer of the bar, which pressurizes and deforms the crystal structure of intermediate layers, and simultaneously begins to temper the quenched layers using the heat from the bar's core. Steel billets 130mm² ("pencil ingots") are heated to approximately 1200°C to 1250°C in a reheat furnace.
Ausforming, also known as low and high temperature thermomechanical treatments, is a method used to increase the hardness and toughness of an alloy by simultaneously tempering, rapid cooling, deforming and quenching to change its shape and refine the microstructure. [1] This treatment is an important part in the processing of steel. [2]
As with conventional quench and tempering the material being heat treated must be cooled from the austenitizing temperature quickly enough to avoid the formation of pearlite. The specific cooling rate that is necessary to avoid the formation of pearlite is a product of the chemistry of the austenite phase and thus the alloy being processed.