Ads
related to: insoles which way up to turn water softener pressure loss on bottom of faucet
Search results
Results From The WOW.Com Content Network
Backflow prevention device. The simplest, most reliable way to provide backflow prevention is to provide an air gap.An air gap is simply an open vertical space between any device that connects to a plumbing system (like a valve or faucet) and any place where contaminated water can collect or pool.
Water can easily fall from the faucet into the sink, but there is no way that water can be drawn up from the sink into the faucet. This arrangement prevents any contaminants in the sink from entering into the potable water system by siphonage ; this is the simplest form of backflow prevention.
A double check valve or double check assembly (DCA) is a backflow prevention device designed to protect water supplies from contamination. [1] It is different from the two-way check valves (sometimes erroneously referred to as double check valves) used in air brake systems on heavy trucks which select from the highest pressure source.
A low-flow fixture is a water saving plumbing fixture designed to achieve water savings by having a lower flow rate of water or a smaller quantity per flush. Some of these low-flow fixtures are faucets, showerheads, and toilets.
Water to be filtered is then applied to the filter surface until the filter clogs and the backwash cycle needs to be repeated. [3]: 264–8 [4]: 10.53–10.58 [5]: 937–9 [6]: 8.11–8.18 [7]: 353–6 Some water treatment filters use surface wash systems that break up the heavily clogged, granular media surface layer.
When an aerator is added to the faucet (or fluid stream), there is a region of high pressure created behind the aerator. Because of the higher pressure behind the aerator and the low pressure in front of it (outside the faucet), due to Bernoulli's principle there is an increase in velocity of the fluid flow.
Orifice plate showing vena contracta. An orifice plate is a thin plate with a hole in it, which is usually placed in a pipe. When a fluid (whether liquid or gaseous) passes through the orifice, its pressure builds up slightly upstream of the orifice [1] but as the fluid is forced to converge to pass through the hole, the velocity increases and the fluid pressure decreases.
The initial nucleation of the gas bubbles can occur due to depressurization of the hard water as it flows up a water well just like when the top comes off of a beer bottle. Once carbon dioxide leaves the liquid a chemical reaction immediately drives formation of calcium carbonate crystals on the surface of the bubbles.