Search results
Results From The WOW.Com Content Network
MOSFET gate driver is a specialized circuit that is used to drive the gate (gate driver) of power MOSFETs effectively and efficiently in high-speed switching applications. The addition of high-speed MOSFET gate drivers are the last step if the turn-on is intended to fully enhance the conducting channel of the MOSFET technology.
If the MOSFET is an n-channel or nMOS FET, then the source and drain are n+ regions and the body is a p region. If the MOSFET is a p-channel or pMOS FET, then the source and drain are p+ regions and the body is a n region. The source is so named because it is the source of the charge carriers (electrons for n-channel, holes for p-channel) that ...
A gate driver is a power amplifier that accepts a low-power input from a controller IC and produces a high-current drive input for the gate of a high-power transistor such as an IGBT or power MOSFET. Gate drivers can be provided either on-chip or as a discrete module. In essence, a gate driver consists of a level shifter in combination with an ...
A power MOSFET is a specific type of metal–oxide–semiconductor field-effect transistor (MOSFET) designed to handle significant power levels. Compared to the other power semiconductor devices , such as an insulated-gate bipolar transistor (IGBT) or a thyristor , its main advantages are high switching speed and good efficiency at low voltages.
Open drain output uses MOS transistor (MOSFET) instead of BJTs, and expose the MOSFET's drain as output. [1]: 488ff An nMOS open drain output connects to ground when a high voltage is applied to the MOSFET's gate, or presents a high impedance when a low voltage is applied to the gate.
The MOSFET (metal–oxide–semiconductor field-effect transistor) utilizes an insulator (typically SiO 2) between the gate and the body. This is by far the most common type of FET. The DGMOSFET (dual-gate MOSFET) or DGMOS, a MOSFET with two insulated gates. The IGBT (insulated-gate bipolar transistor) is a device for power control. It has a ...
Another method for driving MOSFET-bridges is the use of a specialised transformer known as a GDT (gate drive transformer), which gives the isolated outputs for driving the upper FETs gates. The transformer core is usually a ferrite toroid, with 1:1 or 4:9 winding ratio. However, this method can only be used with high frequency signals.
In most circuits, this means pulling an enhancement-mode MOSFET's gate voltage towards its drain voltage turns it on. In a depletion-mode MOSFET, the device is normally on at zero gate–source voltage. Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example).