Ad
related to: idle torque converter problems symptoms
Search results
Results From The WOW.Com Content Network
Idle creep, sometimes called idle speed or just creep [citation needed] is the default speed that a vehicle with an automatic transmission will move either forward or in reverse when the change lever is in D for drive or R for reverse and the foot is taken off the brake pedal but the accelerator pedal is not depressed. This behaviour is due to ...
Known as an input speed sensor (ISS). This sensor sends a varying frequency signal to the TCU to determine the current rotational speed of the input shaft or torque converter. The TCU uses the input shaft speed to determine slippage across the torque converter and potentially to determine the rate of slippage across the bands and clutches. This ...
ZF torque converter cut-away A cut-away model of a torque converter. A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
Some areas of failure on this transmission include leaks in the oil filling tube by removing the cap incorrectly, damage to plastic internals due to fluid over-temperature conditions, leaks in the transmission oil cooler, internal fluid pressure leaks from torn piston diaphragms, worn piston bores for solenoids in aluminum valve body, and the resulting worn clutches and bands.
Since the torque tube does not constrain the car's body to the axle in the lateral (side-to-side) direction, a panhard rod is often used for this purpose. The combination of the panhard rod and the torque tube allows the easy implementation of soft coil springs in the rear to give good ride quality, as in Buicks after 1937.
Because it was based on the "X" transmissions, its gear ratios from 1-3 were the same, with the fourth being 0.67:1. The transmission featured a split-torque application for third gear as well as a lockup in the torque converter. The XT-LOD was initially abandoned in 1966, but the design began again in 1974 because of rising gas prices.
The Ford Duratorq engine, commonly referred to as Duratorq, is the marketing name of a range of Ford diesel engines introduced in 2000. The larger capacity 5-cylinder units use the Power Stroke branding when installed in North American-market vehicles.
Gliding vehicles equipped with torque converter-based automatic transmissions causes damage due lack of lubrication. Also, restarting the engine by clutch from the vehicle's kinetic energy or drag is not possible. It is required to use the starter.