Ads
related to: torque converter problems noise
Search results
Results From The WOW.Com Content Network
ZF torque converter cut-away A cut-away model of a torque converter. A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
Torsional vibration is a concern in the crankshafts of internal combustion engines because it could break the crankshaft itself; shear-off the flywheel; or cause driven belts, gears and attached components to fail, especially when the frequency of the vibration matches the torsional resonant frequency of the crankshaft.
Known as an input speed sensor (ISS). This sensor sends a varying frequency signal to the TCU to determine the current rotational speed of the input shaft or torque converter. The TCU uses the input shaft speed to determine slippage across the torque converter and potentially to determine the rate of slippage across the bands and clutches. This ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
Problems with this transmission are well known. [citation needed] This transmission locks up the torque converter in all gears, increasing wear. Combined with a sealed transmission pan and "lifetime fluid", some people have experienced catastrophic transmission failure.
This was a later model of the 125 that debuted for 1982 and included a torque converter clutch or TCC. The TCC acts similar to a clutch in a manual transmission vehicle, in that at speeds above 35 MPH a combination of engine vacuum- and temperature-sensing valves, and a dedicated brake switch - and in later models an ECU - activated a solenoid which engaged a clutch physically locking the ...
Due to its two-speed with torque converter design, the Super Turbine 300 is often confused with Chevrolet's Powerglide — which was also a two-speed torque converter transmission, but the ST 300 had a different design from the Chevy unit, which had been around since 1950. The low band was the same as the 1955 up PG along with the same style ...