Search results
Results From The WOW.Com Content Network
Steel-rule die, also known as cookie cutter dies, are used for cutting sheet metal and softer materials, such as plastics, wood, cork, felt, fabrics, and paperboard. The cutting surface of the die is the edge of hardened steel strips, known as steel rule. These steel rules are usually located using saw or laser-cut grooves in plywood.
Rotary die cutting is die cutting using a cylindrical die on a rotary press and may be known as a rotary die cutter or RDC. A long sheet or web of material will be fed through the press into an area known as a "station" which holds a rotary tool that will cut out shapes, make perforations or creases, or even cut the sheet or web into smaller parts.
A die cuts an external thread on cylindrical material, such as a rod, which creates a male threaded piece that functions like a bolt. Dies are generally made in two styles: solid and adjustable. An adjustable die may be adjusted either by an integrated screw or by a set of screws set in to the die holder (termed a "die stock").
Shearing, also known as die cutting, [1] is a process that cuts stock without the formation of chips or the use of burning or melting. Strictly speaking, if the cutting blades are straight the process is called shearing; if the cutting blades are curved then they are shearing-type operations. [ 2 ]
The second die type, known as a pressure type die, relies on contact between the jacketing polymer and bare wire inside the die. In this die type, a ring of polymer melt under pressure is forced around the bare wire. Due to the applied pressure of the melt, the opening around the inlet for the bare wire must be very small, on the order of 0.05 mm.
Shearing may be permitted only in certain areas of the sheet due to limitations of the machinery (e.g. always across the whole sheet); Some cutting technologies (plasma) require some minimal offset between the parts; Nesting software may also have to take into account material characteristics, such as: Defects on material that must be discarded;
A common post-extrusion process for plastic sheet stock is thermoforming, where the sheet is heated until soft (plastic), and formed via a mold into a new shape. When vacuum is used, this is often described as vacuum forming. Orientation (i.e. ability/ available density of the sheet to be drawn to the mold which can vary in depths from 1 to 36 ...
The mold cavity is created using two hardened tool steel dies which have been machined into shape and work similarly to an injection mold during the process. Most die castings are made from non-ferrous metals, specifically zinc, copper, aluminium, magnesium, lead, pewter, and tin-based alloys. Depending on the type of metal being cast, a hot ...