Search results
Results From The WOW.Com Content Network
IS: 1199 – methods of sampling and analysis of concrete. IS: 516BXB JWJJS– methods of test for strength of concrete. IS: 13311 – ultrasonic testing of concrete structures. IS: 4925 – specifications for concrete batching plant. IS: 3025 – tests on water samples; IS: 4990 – specifications for plywood formwork for concrete.
Data from Heron/Shoval/Eitan General characteristics Capacity: 250 kg (551 lb) Length: 8.5 m (27 ft 11 in) Wingspan: 16.6 m (54 ft 6 in) Airfoil: IAI SA-21 Max takeoff weight: 1,150 kg (2,535 lb) Powerplant: 1 × Rotax 916 4-cylinder air and water cooled horizontally-opposed piston engine, 160 kW (210 hp) Propellers: 3-bladed pusher propeller Performance Maximum speed: 207 km/h (129 mph, 112 ...
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils. Based on this history it has also been called the "Dutch ...
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...
Typically concrete slabs perform better than implied by their R-value. [5] The R-value does not consider thermal mass, since it is tested under constant temperature conditions. Thus, when a concrete slab is subjected to fluctuating temperatures, it will respond more slowly to these changes and in many cases increase the efficiency of a building ...
Thermal Integrity Profiling (TIP) is a non-destructive testing method used to evaluate the integrity of concrete foundations. It is standardized by ASTM D7949 - Standard Test Methods for Thermal Integrity Profiling of Concrete Deep Foundations. The testing method was first developed in the mid 1990s at the University of South Florida.
The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...