Ads
related to: painting concrete basement walls to look like brick siding over drywall
Search results
Results From The WOW.Com Content Network
Depending on the 'look' required, rendering can be fine or coarse, textured or smooth, natural or colored, pigmented or painted. The cement rendering of brick, concrete and mud houses has been used for centuries to improve the appearance (and sometimes weather resistance) of exterior walls. It can be seen in different forms all over southern ...
The trowel is then run over the surface of the drywall, knocking off the stalactites and leaving the mottled finish. A much more common, and faster technique is to apply the texture mud (which is slightly different from joint compound, in that it has less shrinkage upon drying) with a texture machine – a compressor and a texture spray hopper ...
It is used as a decorative coating for walls and ceilings, exterior walls, and as a sculptural and artistic material in architecture. Stucco can be applied on construction materials such as metal, expanded metal lath, concrete, cinder block, or clay brick and adobe for decorative and structural purposes. [2]
Without a strong bond between the Formstone and the underlying brick, moisture is allowed to enter between the two materials and become trapped. Applying Formstone to rowhouses constructed with early brick from the eighteenth and nineteenth centuries caused many problems. This early brick was soft, porous, and susceptible to deterioration. [13]
At the place where the two edges of wallboards meet there is a seam. These seams are covered with mesh tape and then the seams and the screw heads are concealed with the drywall compound to make the wall seem as one uniform piece. The drywall plaster is a thick paste. Later this is painted or wallpapered over to hide the work.
Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.