When.com Web Search

  1. Ads

    related to: gas powered dirty water pump

Search results

  1. Results From The WOW.Com Content Network
  2. Humphrey pump - Wikipedia

    en.wikipedia.org/wiki/Humphrey_Pump

    The demonstration pump exhibited at the Brussels exhibition was tested by Prof W.C Unwin in 1909 [5] and was found to require around 33% less fuel gas than would have been consumed had contemporary gas burning engines been used drive pumps moving the same amount of water to the same height. [2]

  3. Water pumping - Wikipedia

    en.wikipedia.org/wiki/Water_pumping

    Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...

  4. Comparison of pumps - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_pumps

    Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

  5. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...

  6. Hydraulic ram - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_ram

    A hydraulic ram pump, ram pump, or hydram is a cyclic water pump powered by hydropower. It takes in water at one "hydraulic head" (pressure) and flow rate, and outputs water at a higher hydraulic head and lower flow rate. The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to ...

  7. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    Typically, water is channeled from a high-level reservoir to a low-level reservoir, through turbine generators that generate electricity. This is done when the station is required to generate power. During low-demand periods, such as overnight, the generators are reversed to become pumps that move the water back up to the top reservoir.