Search results
Results From The WOW.Com Content Network
The All Routers multicast group addresses all routers on the same network segment. No 224.0.0.4 This address is used in the Distance Vector Multicast Routing Protocol (DVMRP) to address multicast routers. No 224.0.0.5 The Open Shortest Path First (OSPF) All OSPF Routers address is used to send Hello packets to all OSPF routers on a network ...
The destination PE router then decapsulates the traffic and forwards it to the CE router at the destination. The backbone network is completely transparent to the customer equipment, allowing multiple customers or user communities to use the common backbone network while maintaining end-to-end traffic separation.
Multihoming is the practice of connecting a host or a computer network to more than one network. This can be done in order to increase reliability or performance. A typical host or end-user network is connected to just one network. Connecting to multiple networks can increase reliability because if one connection fails, packets can still be routed through the remaining connection. Connecting ...
In cases where secondary/standby routers all have the same priority, the secondary/standby router with the highest IP address becomes the primary/active router. All physical routers acting as a virtual router must be in the same local area network (LAN) segment. Communication within the virtual router takes place periodically.
The Common Address Redundancy Protocol or CARP is a computer networking protocol which allows multiple hosts on the same local area network to share a set of IP addresses. Its primary purpose is to provide failover redundancy, especially when used with firewalls and routers. In some configurations, CARP can also provide load balancing ...
If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use. If there are multiple routes with the same subnet mask and metric, the system may use equal-cost multi-path routing as a forwarding strategy.
Two routers must first be neighbors and only then, can they become adjacent. Two routers become adjacent if at least one of them is designated router or backup designated router (on multiaccess-type networks), or they are interconnected by a point-to-point or point-to-multipoint network type.
While a router may run multiple routing protocols on the same device, it is necessary for the router to implement a process to ensure that multiple routes, pointing to the same destination do not simultaneously exist in the routing table. Each process running on a router advertises its administrative distance value to the local router.