Ads
related to: how to determine ecm failure with fluid
Search results
Results From The WOW.Com Content Network
Fault Recovery in FDIR is the action taken after a failure has been detected and isolated to return the system to a stable state. Some examples of fault recoveries are: Switch-off of a faulty equipment; Switch-over from a faulty equipment to a redundant equipment; Change of state of the complete system into a Safe Mode with limited functionalities
An ECU from a Geo Storm. An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
Under the functional failure mode approach, the actual functional failure modes of the product are identified during a DFMEA. During the detailed FMEDA, each component failure mode is mapped to a functional failure mode. The functional failure modes are then categorized according to product failure mode in a particular application. [13]
This input is used to determine whether to activate the shift lock solenoid to prevent the driver from selecting a driving range with no foot on the brake. In more modern TCUs this input is also used to determine whether to downshift the transmission to increase engine braking effect if the transmission detects that the vehicle is going ...
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine.
This interface was made in different varieties and changed with power train control modules (aka PCM, ECM, ECU). Different versions had slight differences in pin-outs and baud rates. Earlier versions used a 160 baud rate, while later versions went up to 8192 baud and used bi-directional communications to the PCM. [15] [16]
A mass (air) flow sensor (MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine. The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its density with temperature and pressure.
This was a later model of the 125 that debuted for 1982 and included a torque converter clutch or TCC. The TCC acts similar to a clutch in a manual transmission vehicle, in that at speeds above 35 MPH a combination of engine vacuum- and temperature-sensing valves, and a dedicated brake switch - and in later models an ECU - activated a solenoid which engaged a clutch physically locking the ...