Ads
related to: usb 2.0 speed test software for pc computer
Search results
Results From The WOW.Com Content Network
Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts ...
The Hi-Speed USB logo. USB 2.0 was released in April 2000, adding a higher maximum signaling rate of 480 Mbit/s (maximum theoretical data throughput 53 MByte/s [25]) named High Speed or High Bandwidth, in addition to the USB 1.x Full Speed signaling rate of 12 Mbit/s (maximum theoretical data throughput 1.2 MByte/s). [26]
The USB-C plug USB cable with a USB-C plug and a USB-C port on a notebook computer. The USB-C connector supersedes all earlier USB connectors and the Mini DisplayPort connector. It is used for all USB protocols and for Thunderbolt (3 and later), DisplayPort (1.2 and later), and others.
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
USB 3.0 SuperSpeed and USB 2.0 High-Speed versions defined USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions
USB OTG is a part of a supplement [2] to the Universal Serial Bus (USB) 2.0 specification originally agreed upon in late 2001 and later revised. [3] The latest version of the supplement also defines behavior for an Embedded Host which has targeted abilities and the same USB Standard-A port used by PCs.
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.