Ads
related to: 3.5 floppy disk drive internal monitor cable
Search results
Results From The WOW.Com Content Network
A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector. This allows two drives ...
the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).
Under these, a carrying handle. At the rear two proprietary Apricot connector slots for expansion, parallel printer port of Centronics micro ribbon 36 pin connector type, serial port DB-25 connector, monitor connector and power supply with a switch. Support for two internal 3,5" Sony floppy disk drives; Input / Output: External monitor connector.
The 1541 was the standard floppy disk drive for the Commodore 64, with nearly all disk-based software programs released for the computer being distributed in the 1541 compatible floppy disk format. The 1541 was very slow in loading programs because of a poorly implemented serial bus , a legacy of the VIC-20 .
The Timex FDD 3000 is an upgraded Timex FDD (sometimes known as the FDD3 because it consisted of three separate boxes: a floppy-disk drive, the controller and the power supply). [ 3 ] [ 1 ] [ 2 ] The Timex FDD3 was intended as a floppy disk peripheral for the Timex TC 2048 or TC 2068 microcomputers . [ 3 ]
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
An external 5.25-inch floppy drive, matching the style of the IIc, was also made available. Later, 3.5-inch floppy storage became an option with the "intelligent" UniDisk 3.5 which contained its own miniature computer inside (CPU, RAM, firmware) to overcome the issue of using a high-speed floppy drive on a 1 MHz machine.