Search results
Results From The WOW.Com Content Network
1981 (August, reprinted March 2013): New Perspectives in Wood Anatomy: Published on the Occasion of the 50th Anniversary of the International Association of Wood Anatomists [10] 1989: IAWA List of Microscopic Features for Hardwood Identification [11] 1994: Directory of Members [12] 1996: Recent advances in wood anatomy [13]
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
The joint is formed by cutting opposing tapered ends on each member which are then fitted together. When working with wood, this gives better long grain to long grain gluing surface, which yields a stronger joint than would be achieved with a simple butt joint. The tapers are generally cut at an angle between 1:8 to 1:10.
This is the most common form of end lap and is used most in framing. For a half lap in which the members are parallel, the joint may be known as a half lap splice. This is a splice joint and is an alternative to scarfing when joining shorter members end to end. Both members in an end lap have one shoulder and one cheek each. Use for:
A dutchman, or in some uses graving piece, is a matching piece of good material used to replace a relatively small damaged area that has been cut out of a larger item, to avoid having to replace the entire item; or, any of various techniques for accomplishing such a repair.
In cope and stick construction, the "stick" is the molded edge with a cut along the inside of the frame where it is to be joined to the panel. The panel piece that meets the molding at a right angle must be "coped," or given a cope cut, across the end grain of the wood to match the molding's profile. [2
A typical marlinspike with lanyard A large marlinspike being used to splice a 2 + 1 ⁄ 2-inch (6.4 cm) wire cable. A marlinspike (/ ˈ m ɑːr l ɪ n s p aɪ k /, sometimes spelled marlin spike, marlinespike, or [archaic] marlingspike) is a tool used in marine ropework.
This tape is used extensively in aviation and aerospace wiring applications as a splice or wrapping tape due to its non-flammability. [citation needed] It can be used for emergency repair of leaking low-pressure hoses and pipes. Compared to most other electrical and utility tapes, centerline tape is not particularly tough mechanically.