Ads
related to: moog coil spring rate chart for ktm 85 dirt bikemotosport.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Most motorcycles today use telescopic forks for the front suspension. The forks can most easily be understood as simply encased long coil springs with hydraulic damping of excess spring energy. They allow the front wheel to react to imperfections in the road while isolating the rest of the motorcycle from that motion. Telescopic forks on a 1969 BMW
WP rear shock unit on a KTM 950 Adventure in 2007. WP Suspension GmbH is a manufacturer of components for motorcycle suspension systems based in Austria. The company was founded in 1977 by Wim Peters in Malden, Netherlands [1] and is amongst the largest manufacturers of suspension components for motorcycles. [2]
A selection of conical coil springs. Spring rate is the measurement of how much a coil spring can hold until it compresses 1 inch (2.54 cm). The spring rate is normally specified by the manufacture. If a spring has a rate of 100 then the spring would compress 1 inch with 100 pounds (45 kg) of load. [1]
Motocross – The current Motocross line designated by SX includes 50, 65, 85, 105, 125, 150, 250 and 300 cc single-cylinder two-stroke models (the 50 SX, 65 SX and 85 SX models are kids' and youth bikes), and 250, 350 and 450 cc single-cylinder four-stroke models (SX-F). [38] In 2005 KTM released the new 250SX-F to the general public.
A torsion spring's rate is in units of torque divided by angle, such as N·m/rad or ft·lbf/degree. The inverse of spring rate is compliance, that is: if a spring has a rate of 10 N/mm, it has a compliance of 0.1 mm/N. The stiffness (or rate) of springs in parallel is additive, as is the compliance of springs in series.
The following table gives formula for the spring that is equivalent to a system of two springs, in series or in parallel, whose spring constants are and . [1] The compliance c {\displaystyle c} of a spring is the reciprocal 1 / k {\displaystyle 1/k} of its spring constant.)
Pneumatic and hydraulic shock absorbers are used in conjunction with cushions and springs. An automobile shock absorber contains spring-loaded check valves and orifices to control the flow of oil through an internal piston (see below). [1] One design consideration, when designing or choosing a shock absorber, is where that energy will go.
The force in the spring is (roughly) the vertical force at the contact patch divided by the motion ratio, and the spring rate is the wheel rate divided by the motion ratio squared. I R = S p r i n g D i s p l a c e m e n t W h e e l D i s p l a c e m e n t . {\displaystyle IR={\frac {SpringDisplacement}{WheelDisplacement}}.}