When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Motorola connector - Wikipedia

   en.wikipedia.org/wiki/Motorola_connector

   A Motorola connector (also called a Motorola antenna plug [citation needed] or a male DIN 41585 [1]) is a common coaxial cable RF connector used primarily in the automotive industry for connecting the coaxial feedline from the antenna to the radio receiver. It is also sometimes used for connecting scanner antennas to scanners.

3. Fishtailing - Wikipedia

   en.wikipedia.org/wiki/Fishtailing

   Fishtailing is a vehicle handling problem which occurs when the rear wheels lose traction, resulting in oversteer. This can be caused by low- friction surfaces (sand, gravel, rain, snow, ice, etc.). Rear-drive vehicles with sufficient power can induce this loss of traction on any surface, which is called power-oversteer .

4. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   The male contact was designed to be the same size as the cable conductor so that it could be used as the mating pin for optimized VSWR. Common applications included Mil-Aero, telecommunications, RFID, antennas, test and measurement and radar systems. SMZ connector – System 43 (BT43 and High Density HD43) for use in DDF. This is a 75 ohm ...

5. Whip antenna - Wikipedia

   en.wikipedia.org/wiki/Whip_antenna

   Whip antenna on portable FM radio receiver Whip antenna on car. A whip antenna is an antenna consisting of a straight flexible wire or rod. The bottom end of the whip is connected to the radio receiver or transmitter. A whip antenna is a form of monopole antenna. The antenna is designed to be flexible so that it does not break easily, and the ...

6. Coaxial antenna - Wikipedia

   en.wikipedia.org/wiki/Coaxial_antenna

   In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...

7. Twin-lead - Wikipedia

   en.wikipedia.org/wiki/Twin-lead

   Twin lead cable is a two-conductor flat cable used as a balanced transmission line to carry radio frequency (RF) signals. It is constructed of two, stranded copper wires, or solid copper-clad steel wires. The wires are held a fixed distance apart by a plastic ribbon that is a good insulator at radio frequencies (usually polyethylene).