Search results
Results From The WOW.Com Content Network
understeer and oversteer where front or rear wheels lose traction during cornering, causing a vehicle to follow a larger or smaller turning radius. burnout where a vehicle slips or spins its tires during acceleration. lockup where a vehicle skids during braking (with or without directional or yaw changes).
The original design of the braking system within the 14-bolt differentials accommodated diverse wheel sizes, initially fitting drums suitable for 15-inch wheels and later adapting to cater to the needs of 3/4-ton and 1-ton vehicles.
The OEM Limited slip differential originally was a "Power Lok" until 1998 when the "Trac Lok" phased it out. Trac Loks were a US$350.00 option with Ford Super Duty trucks. [ 1 ] The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions.
The Volkswagen Transporter, initially the Type 2, [2] is a range of light commercial vehicles, built as vans, pickups, and cab-and-chassis variants, introduced in 1950 by the German automaker Volkswagen as their second mass-production light motor vehicle series, and inspired by an idea and request from then-Netherlands-VW-importer Ben Pon.
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
These were either LT40 or LT45 (rated 4 or 4.5 tonne). Opposed to the normal LT40 & LT45, the 4x4s only had single wheels on the rear axle. The chassis is lifted, 26mm anti-roll bars are added to cope with body-roll and the axles are replaced. A propshaft driven, rod/shaft controlled transfer box was installed under the vehicle.
A 4-speed transaxle which replaced the 125, was created for the 1985–1986 GM C platform (FWD)/GM H platform (FWD) cars, the Turbo-Hydramatic 440-T4. Virtually no internal parts were shared with the 125, and overdrive was achieved by departing radically from the standard single Simpson compound planetary gearset 's common sungear layout.