Search results
Results From The WOW.Com Content Network
This thrust record was reached inadvertently as part of a one-hour, triple-red-line engine stress test using a GE90-115B development engine at GE's outdoor test complex near Peebles, Ohio. It eclipsed the engine's previous Guinness world record of 122,965 lbf (546.98 kN). [ 28 ]
In February 2012, GE announced studies on a more efficient derivative of the GE90, calling it the GE9X, to power both the -8 and -9 variants of the new Boeing 777X.It was to feature the same 128 in (325 cm) fan diameter as the GE90-115B with thrust decreased by 15,800 lbf (70 kN) to a new rating of 99,500 lbf (443 kN) per engine. [1]
GE Aviation's offering is the GEnx, a development of the GE90. The engine was also the exclusive power plant on the Boeing 747-8. The Lynn facility continues to assemble jet engines for the United States Department of Defense, subsidiary services, and commercial operators. Engines assembled at this plant include the F404, F414, T700, and CFE738.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
The type of jet engine used to explain the conversion of fuel into thrust is the ramjet.It is simpler than the turbojet which is, in turn, simpler than the turbofan.It is valid to use the ramjet example because the ramjet, turbojet and turbofan core all use the same principle to produce thrust which is to accelerate the air passing through them.
GE Aviation, part of the General Electric conglomerate, currently has the largest share of the turbofan engine market. Some of their engine models include the CF6 (available on the Boeing 767, Boeing 747, Airbus A330 and more), GE90 (only the Boeing 777) and GEnx (developed for the Boeing 747-8 & Boeing 787 Dreamliner and proposed for the Airbus A350) engines.
GEnx on 747-8I prototype. As of 2016, the GEnx and the Rolls-Royce Trent 1000 were selected by Boeing following a run-off between the three big engine manufacturers. The GEnx uses some technology from the GE90 turbofan, [1] including swept composite fan blades and the 10-stage high-pressure compressor (HPC) featured in earlier variants of the engine.
The American Federal Aviation Administration certified the engine for commercial operation on January 4, 2006. [4] The engine was ground run for the first time on an A380 on August 14, 2006, in Toulouse. [5] On August 25, 2006, the same aircraft, A380-861 test aircraft (MSN 009), made the first flight of an Engine Alliance powered A380.