Search results
Results From The WOW.Com Content Network
A centrifugal fan is a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid. Centrifugal fans often contain a ducted housing to direct outgoing air in a specific direction or across a heat sink; such a fan is also called a blower, blower fan, or squirrel-cage fan (because it looks like a hamster wheel).
In the mid-1960s, Chrysler decided to adapt the 318 cu in (5.2 L) small block V8 into a lightweight, high output engine equally suited for drag strip or street performance use. Its block was bored out to 4.04 in (102.6 mm) but its 3.31 in (84.1 mm) stroke left unchanged, resulting in the 340 cu in (5.6 L) engine introduced for the 1968 model year.
The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at a different speed or impeller diameter. The only requirement is that the two pumps or fans are dynamically similar, that is, the ratios of the fluid forced are the same.
In aeronautics, a ducted fan is a thrust-generating mechanical fan or propeller mounted within a cylindrical duct or shroud. Other terms include ducted propeller or shrouded propeller . [ 1 ] When used in vertical takeoff and landing ( VTOL ) applications it is also known as a shrouded rotor .
The fan is designed to produce a pressure difference, and hence force, to cause a flow through the fan. Factors which determine the performance of the fan include the number and shape of the blades. Fans have many applications including in wind tunnels and cooling towers. Design parameters include power, flow rate, pressure rise and efficiency. [1]
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
Industrial fans and blowers are machines whose primary function is to provide and accommodate a large flow of air or gas to various parts of a building or other structures. This is achieved by rotating a number of blades, connected to a hub and shaft, and driven by a motor or turbine.
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.