Ads
related to: how bright is 1 nit rated cable connected to 3 1/2 ft
Search results
Results From The WOW.Com Content Network
The sRGB spec for monitors targets 80 cd/m 2. [3] Typically, monitors calibrated for SDR broadcast or studio color grading should have a brightness of 100 cd/m 2 . [ 4 ] Most consumer desktop liquid crystal displays have luminances of 200 to 300 cd/m 2 . [ 5 ]
Tri-rated cable is a high temperature, flame retardant electrical wire designed for use inside electrical equipment. Tri-rated cable meets the requirements of three different international standards: BS 6231, UL 758, and CSA 22.2. [ 1 ]
A foot-lambert or footlambert (fL, sometimes fl or ft-L) is a unit of luminance in United States customary units and some other unit systems. A foot-lambert equals 1/π or 0.3183 candela per square foot, or 3.426 candela per square meter (the corresponding SI unit).
Luminance is a photometric measure of the luminous intensity per unit area of light travelling in a given direction. [1] It describes the amount of light that passes through, is emitted from, or is reflected from a particular area, and falls within a given solid angle .
[1] Hot is any line or neutral conductor (wire or otherwise) connected with an electrical system that has electric potential relative to electrical ground or line to neutral. Ground is a safety conductor with a low impedance path to earth. It is often called the "ground wire," or safety ground. It is either bare or has green insulation. [1]
The term candlepower was originally defined in the United Kingdom, by the Metropolitan Gas Act 1860, as the light produced by a pure spermaceti candle that weighs 1 ⁄ 6 pound (76 grams) and burns at a rate of 120 grains per hour (7.8 grams per hour).
Researchers found exposure to brighter light at night predicted higher risk of type 2 diabetes across an average of eight years of follow-up. Bright light at night from phones, cable box can boost ...
If a lamp has a 1 lumen bulb and the optics of the lamp are set up to focus the light evenly into a 1 steradian beam, then the beam would have a luminous intensity of 1 candela. If the optics were changed to concentrate the beam into 1/2 steradian then the source would have a luminous intensity of 2 candela.