Ads
related to: closet rod support spacing calculator tool
Search results
Results From The WOW.Com Content Network
Topographer's rods are special purpose rods used in topographical surveys. The rod has the zero mark at mid-height and the graduations increase in both directions away from the mid-height. In use, the rod is adjusted so that the zero point is level with the instrument (or the surveyor's eye if he is using a hand level for low-resolution work).
Before the advent of the scientific pocket calculator, it was the most commonly used calculation tool in science and engineering. [3] The slide rule's ease of use, ready availability, and low cost caused its use to continue to grow through the 1950s and 1960s, even as desktop electronic computers were gradually introduced.
In the rod's frame of reference, the front of the rod is first accelerated downward (shown in cell 3 of the drawing), and as time goes by, more and more of the rod is subjected to the downward acceleration, until finally the back of the rod is accelerated downward. This results in a bending of the rod in the rod's frame of reference.
A rod end bearing, also known as a heim joint (North America) or rose joint (UK and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect alignment between the components ...
The distance (or perpendicular distance) from a point to a line is the shortest distance from a fixed point to any point on a fixed infinite line in Euclidean geometry.It is the length of the line segment which joins the point to the line and is perpendicular to the line.
In chemistry, a retort stand, also called a clamp stand, [1] a ring stand, [2] or a support stand, [3] is a piece of scientific equipment intended to support other pieces of equipment and glassware — for instance, burettes, test tubes and flasks. [4] The typical ring stand consists of a heavy base and a vertical rod, both usually made of metal.
A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.
Modern columns may be constructed out of steel, poured or precast concrete, or brick, left bare or clad in an architectural covering, or veneer. Used to support an arch, an impost, or pier, is the topmost member of a column. The bottom-most part of the arch, called the springing, rests on the impost.