Ads
related to: gas line tape vs sealant coating foam material
Search results
Results From The WOW.Com Content Network
Polyurethane is a closed-cell foam insulation material that initially contains a low-conductivity gas in its cells. [6] As a result of the high thermal resistance of the gas, spray polyurethane insulation typically has an initial R-value around R-3.4 to R-6.7 per inch. [6] In comparison, glass wool typically has an R-Value of only R-3 to R-4 ...
The first heat-shrinkable sleeves were introduced [when?] as polyethylene pipeline coatings started to replace bituminous or tape coatings in the oil and gas industry. At the time, the processing for polyethylene to make the sleeve backing was new technology and the adhesives used in sleeves were much the same as those used on pipeline coating.
Sealant is a substance used to block the passage of fluids through openings in materials, [1] a type of mechanical seal. In building construction sealant is sometimes synonymous with caulk (especially if acrylic latex or polyurethane based) [2] and also serve the purposes of blocking dust, sound and heat transmission. Sealants may be weak or ...
Materials for use in vacuum are materials that show very low rates of outgassing in vacuum and, where applicable, are tolerant to bake-out temperatures. The requirements grow increasingly stringent with the desired degree of vacuum to be achieved in the vacuum chamber. The materials can produce gas by several mechanisms.
Continuous foam separation is a chemical process closely related to foam fractionation in which foam is used to separate components of a solution when they differ in surface activity. In any solution, surface active components tend to adsorb to gas-liquid interfaces while surface inactive components stay within the bulk solution.
A typical PSA tape consists of a pressure-sensitive adhesive (the sticky part of the tape) coated to a backing material. To prevent the adhesive from sticking to the backing when wound in a roll, a release agent is applied to the backing or a release liner is placed on the adhesive. Sometimes a primer is coated between the adhesive and backing ...