Search results
Results From The WOW.Com Content Network
Gear Ratios for the AW4: 1st: 2.80; 2nd: 1.53; ... The Dana 300 part-time gear-driven transfer case. [2] That uses a round bolt pattern and has a nearly flat oil pan ...
The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [1] M-500, and M-600 depending on the application. The M600 was offered with the Rockwell F-130-NX rear axle, with a 4.88:1 gear ratio. By 1979, Chrysler Corporation no longer sold incomplete chassis and ended production of the M series.
Warner T-18 (four-speed with a Dana 20 1976-1979) (aftermarket adapters exist for a dana 300, but it was not a factory option) (also known as a three-speed with granny gear) Borg-Warner T-4 (four-speed with a Dana 300) Borg-Warner T-5 (five-speed with a Dana 300) Tremec T-150 (three-speed manual transmission with a Dana 20 1976-1979)
Dana 61 axle tag showing 3.73:1 ratio [1] The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a ...
These Dana 70 axles had open knuckles and ball joints. The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 ...
221 lb⋅ft (300 N⋅m) at 2,000 rpm ... Dana 30, high pinion, reverse cut, 297x/760 universal joint, 27-spline axle shafts ... Axle gear ratios
The Dana/Spicer Model 35 is an automotive axle. ... Many gear ratios were offered over the axle's lifetime: [4] Gear Ratios Ratio:1 Pinion:Ring Teeth 2.21: 19:42
Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.