Search results
Results From The WOW.Com Content Network
A limit switch with a roller-lever operator; this is installed on a gate on a canal lock, and indicates the position of a gate to a control system A limit switch mounted on a moving part of a bridge In electrical engineering , a limit switch is a switch operated by the motion of a machine part or the presence of an object.
Reed switches can be used to directly switch a variety of loads ranging from nanovolts to kilovolts, femtoamperes to amperes, and DC to radio frequency. Other magnetically-activated switching devices have a limited range of output voltages and currents, and generally do not directly control a final device such as a lamp , solenoid , or motor .
A Single-Pole, Single-Throw (SPST) mercury switch on millimetre graph paper, device length approximately 1.5 cm Another mercury switch design. A mercury switch is an electrical switch that opens and closes a circuit when a small amount of the liquid metal mercury connects metal electrodes to close the circuit.
Limiting can refer to a range of treatments designed to limit the maximum level of a signal. Treatments in order of decreasing severity range from clipping, in which a signal is passed through normally but sheared off when it would normally exceed a certain threshold; soft clipping which squashes peaks instead of shearing them; a hard limiter, a type of variable-gain audio level compression ...
A shunt is a device that is designed to provide a low-resistance path for an electrical current in a circuit.It is typically used to divert current away from a system or component in order to prevent overcurrent.
The safety benefit of reducing the power delivered to a short circuit in the load is proportional to the operating current limit. Foldback current limiting is most likely to be found in a switch-mode power supply when it is a component in a product that is independently certified to meet regional safety standards. [2]
Power cannot be re-applied to the kiln until the kiln door is locked, releasing the key, and the key is then returned to the disconnecting switch interlock. [1] A similar two-part interlock system can be used anywhere it is necessary to ensure the energy supply to a machine is interrupted before the machine is entered for adjustment or maintenance.
A problem arises if the electricity supply is upgraded, by adding new generation capacity or by adding cross-connections. Because these increase the amount of power that can be supplied, all of the branch circuits must have their bus bars and circuit breakers upgraded to handle the new higher fault current limit. [citation needed]