Ad
related to: stadia to ft calculator formula conversion factor chart printable
Search results
Results From The WOW.Com Content Network
The interval between stadia marks in most surveying instruments is 10 mrad and gives a stadia interval factor of 100. The distance between the instrument and a stadia rod can be determined simply by multiplying the measurement between the stadia hairs (known as the stadia interval) by 100. The instrument must be level for this method to work ...
This ratio is known as the stadia constant or stadia interval factor. Thus the formula for distance is D = kS. where D is distance from the telescope to the rod; k is the stadia constant; S is the difference between the rod readings at the two stadia marks; For example, a typical stadia mark pair are set so that the ratio is 100.
This article gives a list of conversion factors for several physical quantities.A number of different units (some only of historical interest) are shown and expressed in terms of the corresponding SI unit.
The stadion (plural stadia, Ancient Greek: στάδιον; [1] latinized as stadium), also anglicized as stade, was an ancient Greek unit of length, consisting of 600 Ancient Greek feet . Its exact length is unknown today; historians estimate it at between 150 m and 210 m.
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples:
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
This is converted to distance from the instrument to the stadia rod by multiplying the stadia interval by the stadia interval factor. If the stadia rod is not at the same elevation as the instrument, the value must be corrected for the angle of elevation between the instrument and the rod. The formula most widely used for finding the distances is:
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.