Search results
Results From The WOW.Com Content Network
An engineer, designer, or user should ensure that the pressure and temperature ratings and wetted pump materials are compatible for the application and the type of liquid being pumped. Most metering pumps have a pump head and a motor. The liquid being pumped goes through the pump head, entering through an inlet line and leaving through an ...
Instrumentation and control engineering is a vital field of study offered at many universities worldwide at both the graduate and postgraduate levels. This discipline integrates principles from various branches of engineering, providing a comprehensive understanding of the design, analysis, and management of automated systems.
Some vessels store liquid until it is pumped out. The controller (LIC) acts to start and stop the pump within a specified band. For example, it may start the pump when the level rises to 0.6 m and stop the pump when the level falls to 0.4 m. High and low level alarms (LAH and LAL) warn operating personnel that levels are outside predefined limits.
As a precautionary measure, on December 31, 1999, Colonial Pipeline shut down operations for a few hours before and after midnight to prevent any Y2K-related power outages. [10]: 69 2000. Colonial announced plans to increase pump power on the mainline, which would increase daily capacity by 144,000 barrels to 2.35 million barrels per day.
With wide-beam illumination transit time ultrasound can also be used to measure volume flow independent of the cross-sectional area of the vessel or tube. [19] Ultrasonic Doppler flowmeters measure the Doppler shift resulting from reflecting an ultrasonic beam off the particulates in flowing fluid. The frequency of the transmitted beam is ...
Thermodynamic pump testing is a form of pump testing where only the temperature rise, power consumed, and differential pressure need to be measured to find the efficiency of a pump. These measurements are typically made with insertion temperature probes and pressure probes fitted to tapping points on the pump's inlet and outlet. [ 1 ]
A flow bench consists of an air pump of some sort, a metering element, pressure and temperature measuring instruments such as manometers, and various controls. The test piece is attached in series with the pump and measuring element and air is pumped through the whole system.
The pump used should be a high-pressure, low-volume test, or cementing pump. Rig pumps can be used if the rig has electric drives on the mud pumps, and they can be slowly rolled over. If the rig pump must be used and the pump cannot be easily controlled at low rates, then the leak-off technique must be modified.