Search results
Results From The WOW.Com Content Network
The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.
The brake balance or brake bias of a vehicle is the distribution of brake force at the front and rear tires, and may be given as the percentage distributed to the front brakes (e.g. 52%) [1] or as the ratio of front and rear percentages (e.g. 52/48). [2]
In a belt drive system, idlers are often used to alter the path of the belt, where a direct path would be impractical.. Idler pulleys are also often used to press against the back of a pulley in order to increase the wrap angle (and thus contact area) of a belt against the working pulleys, increasing the force-transfer capacity.
Based upon the size of the clutch or brake, the speed and the inertia, wear rates will differ. For example, a machine that was running at 500 rpm with a clutch and is now sped up to 1000 rpm would have its wear rate significantly increased because the amount of energy required to start the same amount of inertia is a lot higher at the higher speed.
The simplest freewheel device consists of two saw-toothed, spring-loaded discs pressing against each other axially with the toothed sides together, like a ratchet but with the usual stationary part also rotating. Rotating in one direction, the saw teeth of the drive disc lock with the teeth of the driven disc, making it rotate at the same speed.
Stopping sight distance is one of several types of sight distance used in road design.It is a near worst-case distance a vehicle driver needs to be able to see in order to have room to stop before colliding with something in the roadway, such as a pedestrian in a crosswalk, a stopped vehicle, or road debris.
Threshold braking or limit braking is a driving technique most commonly used not only in motor racing, but also practiced in road vehicles to slow a vehicle at the maximum rate using the brakes. [1] The technique involves the driver controlling the brake pedal (or lever) pressure to maximize the braking force developed by the tires .
Because the ratchet can only stop backward motion at discrete points (i.e., at tooth boundaries), a ratchet does allow a limited amount of backward motion. This backward motion—which is limited to a maximum distance equal to the spacing between the teeth—is called backlash.