Search results
Results From The WOW.Com Content Network
Reballing involves dismantling, heating the chip until it can be removed from the board, typically with a hot-air gun and vacuum pickup tool, removing the device, removing solder remaining on the device and board, putting new solder balls in place, replacing the original device if there was a poor connection, or using a new one, and heating the ...
The bootstrap circuit uses a coupling capacitor, formed from the gate/source capacitance of a transistor, to drive a signal line to slightly greater than the supply voltage. [10] Some all-pMOS integrated circuits such as the Intel 4004 and the Intel 8008 use that 2-transistor "bootstrap load" circuit. [11] [12] [13]
Reverse engineering of printed circuit boards (sometimes called “cloning”, or PCB RE) is the process of generating fabrication and design data for an existing circuit board, either closely or exactly replicating its functionality. [1] Obtaining circuit board design data is not by necessity malicious or aimed at intellectual property theft ...
Desoldering may be required to replace a defective component, to alter an existing circuit, or to salvage components for re-use. Use of too high a temperature or heating for too long may damage components or destroy the bond between a printed circuit trace and the board substrate. Techniques are different for through-hole and surface-mounted ...
As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5] Conformal coating gives most of the benefits of potting, and is lighter and easier to inspect, test, and repair. Conformal coatings can be applied as liquid or condensed from a vapor phase.
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
In embedded systems, a board support package (BSP) is the layer of software containing hardware-specific boot loaders, device drivers and other routines that allow a given embedded operating system, for example a real-time operating system (RTOS), to function in a given hardware environment (a motherboard), integrated with the embedded ...
Louis Anthony Rossmann (born November 19, 1988) [3] [4] is an American independent electronics technician, YouTuber, and right to repair activist. He is the owner and operator of Rossmann Repair Group in Austin, Texas (formerly New York City), a computer repair shop established in 2007 which specializes in logic board-level repair of MacBooks.