Ads
related to: 2 inch diameter flexible hose- Single Braided Corrugated
Single Braided Corrugated Hose
from Hosecraft USA
- S/S Unbraided Corrugated
Unbraided Corrugated S/S Hose
from Hosecraft USA
- Double Braided Corrugated
Double Braided Corrugated Hose
from Hosecraft USA
- Triple Braided Corrugated
Triple Braided Corrugated Hose
from Hosecraft USA
- Bronze Braided Corrugated
Bronze Braided Corrugated Hose
from Hosecraft USA
- Interlocked
Interlocked Stainless Steel Hose
from Hosecraft
- Single Braided Corrugated
Search results
Results From The WOW.Com Content Network
5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.
Typically of 2 + 1 ⁄ 2 inches (64 mm) diameter or less in the United States. Historically 1.5 inch hose was the primary initial attack line but has been supplanted in most of the US by 1.75-inch-diameter (44 mm) hose that carries 175 gallons per minute. Two-inch hose is available as an option. Attic ladder
Attack hose is a fabric-covered, flexible hose used to bring water from the fire pumper to the nozzle. This hose ranges in nominal inside diameter from 1.5 to 3 in (38 to 76 mm) and is designed to operate at pressures up to about 400 psi (2,760 kPa). The standard length is 50 ft (15.24 m). [12] Supply and relay hoses
At its annual convention at Dallas, TX, the NFPA formally adopted a standard with 2 + 1 ⁄ 2-inch hose with 7.5 threads per inch as the primary standard, with additional sizes of 3 and 3.5 inches (each with 6 threads per inch) and a 4.5 inch coupling with 4 threads per inch, with the fire hydrant standard specifying one 4.5 inch port and two 2 ...
A barb (or hose barb), which connects flexible hose or tubing to pipes, typically has a male-threaded end which mates with female threads. The other end of the fitting has a single- or multi-barbed tube—a long tapered cone with ridges, which is inserted into a flexible hose.
The US standard was defined by NFPA 1963, "Standard for Fire Hose Connections", [2] then later by ANSI-ASME B1.20.7, [3] which specifies 1 + 1 ⁄ 16 inches (27 mm) diameter straight (non-tapered) thread with a pitch of 11.5 threads per inch (TPI). The female thread is abbreviated FHT (for "female hose thread"), and the male part is abbreviated ...
Ads
related to: 2 inch diameter flexible hose