Search results
Results From The WOW.Com Content Network
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
A crankcase is the housing in a piston engine that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block. Two-stroke engines typically use a crankcase-compression design, resulting in the fuel/air mixture passing through the crankcase before entering the cylinder(s). This design of the engine does ...
The crankshaft configuration varies amongst opposed-engine designs. One layout has a flat/boxer engine at its center and adds an additional opposed-piston to each end so there are two pistons per cylinder on each side. An X engine is essentially two V engines joined by a common crankshaft. A majority of these were existing V-12 engines ...
With a V angle of 90 degrees and offset crank pins, a V-twin engine can have perfect primary balance. If a shared crank pin is used (such as in a Ducati V-twin engine), the 360° crankshaft results in an uneven firing interval. These engines also have primary reciprocating-plane and rotating-plane imbalances.
A properly designed crankcase breather will also be designed in a manner that promotes the scavenging effect, or the creation of suction within the crankcase breather to further aid in the removal of blow-by gases. It is this effect that keeps the crankcase at slightly negative pressure when a properly functioning PCV system is in place. [9]
Note that for the automotive/hotrod use-case the most convenient (used by enthusiasts) unit of length for the piston-rod-crank geometry is the inch, with typical dimensions being 6" (inch) rod length and 2" (inch) crank radius. This article uses units of inch (") for position, velocity and acceleration, as shown in the graphs above.
The cylinder heads are integrated into the engine block, but the crankcase is separate. [2] Typical 1930-1960 flathead engine with integrated crankcase. The cylinder head is tipped upwards for illustrative purposes. An engine where all the cylinders share a common block is called a monobloc engine. Most modern engines use a monobloc design, and ...
Many sorts of machines are crank driven, including unicycles, bicycles, tricycles, various types of machine presses, gasoline engines, diesel engines, steam locomotives, and other steam engines. Crank-driven machines rely on the energy stored in a flywheel to overcome the dead centre, or are designed, in the case of multi-cylinder engines , so ...