Ads
related to: radio shack amplifier for tv reception
Search results
Results From The WOW.Com Content Network
8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.
The Realistic DX-60 is a multiband radio. The radio receives 3 MHz to 27 MHz AM shortwave in three bands, 26.965 MHz through 27.405 MHz HF CB in one band, 540 kHz to 1620 kHz standard AM broadcast in one band, and 87 MHz to 108 MHz monaural standard broadcast FM. The DX-60 existed in two versions, model 12-764 and a nearly identical but ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
When the TV is tuned to the programmed channel, the video and audio signal of the source device is accessed. RF modulation can become difficult in a CATV system. High pass, low pass, and notch filters must be used to block certain frequencies, or channels, so that the modulator can broadcast the audio/video signal of the source device on that ...
The Realistic DX-302 is a general coverage (long-wave, medium-wave, and short-wave) radio manufactured by General Research of Electronics (GRE) of Chiba, Japan and marketed in the United States by Radio Shack (Tandy Corporation) from 1980 through 1982.
A four-channel radio switch and radio-to-power-line transponder To allow for wireless keypads, remote switches, motion sensors, et cetera, an RF protocol is also defined. X10 wireless devices send data packets that are nearly identical to the NEC IR protocol used by many IR remotes, and a radio receiver then provides a bridge which translates ...