When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Wiggler (tool) - Wikipedia

   en.wikipedia.org/wiki/Wiggler_(tool)

   Centering of a shaft with a laser centering device. A centering device is a tool used to accurately adjust and align the center plane or axis of a work piece or work piece feature to the machining center. In contrast to the edge finder, it most often requires no calculation, measurements or layout method markings to allow this alignment.

3. Lathe center - Wikipedia

   en.wikipedia.org/wiki/Lathe_center

   Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy machining ...

4. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   In many lathe tailstocks, the tool is removed by fully withdrawing the quill into the tailstock, which brings the tool up against the end of the leadscrew or an internal stud, separating the taper and releasing the tool. Where the tool is retained by a drawbar, as in some mill spindles, the drawbar is partially unthreaded with a wrench and then ...

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

6. Lathe - Wikipedia

   en.wikipedia.org/wiki/Lathe

   Modern metal lathe A watchmaker using a lathe to prepare a component cut from copper for a watch. A lathe (/ l eɪ ð /) is a machine tool that rotates a workpiece about an axis of rotation to perform various operations such as cutting, sanding, knurling, drilling, deformation, facing, threading and turning, with tools that are applied to the workpiece to create an object with symmetry about ...

7. Facing (machining) - Wikipedia

   en.wikipedia.org/wiki/Facing_(machining)

   Facing on the lathe uses a facing tool to cut a flat surface perpendicular to the work piece's rotational axis. A facing tool is mounted into a tool holder that rests on the carriage of the lathe. The tool will then feed perpendicularly across the part's rotational axis as it spins in the jaws of the chuck.