Ads
related to: luer lock to tubing adapter
Search results
Results From The WOW.Com Content Network
A syringe with a male luer lock fitting, and a needle with female luer lock fitting (purple) which screws into it. The Luer taper is a standardized system of small-scale fluid fittings used for making leak-free connections between a male-taper fitting and its mating female part on medical and laboratory instruments, including hypodermic syringe tips and needles or stopcocks and needles.
It consists, from front to rear, of a hypodermic needle, two bilateral flexible "wings", flexible small-bore transparent tubing (often 20–35 cm long), and lastly a connector (often female Luer). This connector attaches to another device: e.g. syringe , vacuum tube holder/hub, or extension tubing from an infusion pump or gravity-fed infusion ...
The plunger can be linearly pulled and pushed along the inside of the tube, allowing the syringe to take in and expel liquid or gas through a discharge orifice at the front (open) end of the tube. The open end of the syringe may be fitted with a hypodermic needle , a nozzle or tubing to direct the flow into and out of the barrel.
Syringe on left, hypodermic needle with attached colour coded Luer-Lock connector on right Hypodermic needle features. A hypodermic needle (from Greek ὑπο- (hypo-= under), and δέρμα (derma = skin)) is a very thin, hollow tube with one sharp tip.
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.
A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right. JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface.