Search results
Results From The WOW.Com Content Network
A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60. To allow for the different gearing, the Dana 61 had a greater pinion offset.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The Jeep Cherokee (XJ) is a sport utility vehicle manufactured and marketed across a single generation by Jeep in the United States from 1983 (model year 1984) through 2001 — and globally through 2014. It was available in two- or four-door, five-passenger, front-engine, rear- or four-wheel drive configurations.
4D33 – 4214 cc, bore 108 mm × stroke 115 mm, naturally aspirated, ohv gear driven camshaft, direct injection with in-line injection pump. [6] In the Canter trucks (General export model) this engine serves as a standard and outputs 83 kW (113 PS) at 3200 rpm resp. 304 Nm at 1600 rpm, [ 7 ] but output may vary slightly on other trucks/in other ...
To eliminate model overlap, the Rounded Line C/K was renamed the R/V series, which remained as a basis for full-size SUVs and heavier-duty pickup trucks. After an 18-year production run (exceeded only in longevity by the Dodge D/W-series/Ram pickup and the Jeep Gladiator/Pickup), the Rounded Line generation was retired after the 1991 model year.
Work Completed: Replaced gear linkage, entire exhaust system, carpets, body trim including the wheel arches, side skirts and front and rear bumpers, front indicator and tail light lenses, cam belt, water pump, cold start valve, fan belt, petrol cap, new parcel shelf, new front and rear number plates, reset the height of the rear suspension back ...
The solid rear axle from 1995-2001 Explorers is a popular swap for older Jeep Wranglers and Cherokees. In addition to being nearly the same width, they have the same wheel bolt pattern, are equipped with disc brakes, and are much stronger than the Dana 35 they replace.