Search results
Results From The WOW.Com Content Network
Note: In this example, "Run" represents the status of a bit in the PLC, while "Motor" represents the actual output to the real-world relay that closes the motor's real-world circuit. For safety reasons, an emergency stop ("ES") may be hardwired in series with the "Start" switch, and the relay logic should reflect this.
ASME Y14.44-2008 [1] and IEEE 315-1975 [2] define how to reference and annotate components of electronic devices. It breaks down a system into units, and then any number of sub-assemblies. The unit is the highest level of demarcation in a system and is always a numeral.
A Symbolic Analysis of Relay and Switching Circuits is the title of a master's thesis written by computer science pioneer Claude E. Shannon while attending the Massachusetts Institute of Technology (MIT) in 1937, [1] [2] and then published in 1938.
Arduino 68.6 mm × 53.3 mm [ 2.7 in × 2.1 in ] Ethernet serial interface Wiznet Ethernet 5 V 32 1 2 14 4 6 July 13, 2011 [34] Based on the same WIZnet W5100 chip as the Arduino Ethernet Shield. [35] A serial interface is provided for programming, but no USB interface. Late versions of this board support Power over Ethernet (PoE).
Most DC-to-AC converters (power inverters), most AC/AC converters, the DC-to-DC push–pull converter, isolated DC-to-DC converter [2] most motor controllers, and many other kinds of power electronics use H bridges. In particular, a bipolar stepper motor is almost always driven by a motor controller containing two H bridges.
A data link connection identifier (DLCI) is a Frame Relay 10-bit-wide link-local virtual circuit identifier used to assign frames to a specific PVC or SVC. Frame Relay networks use DLCIs to statistically multiplex frames. DLCIs are preloaded into each switch and act as road signs to the traveling frames. [1]
The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A typical circuit consists of a ...
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.