When.com Web Search

  1. Ads

    related to: watertight hatch cover for rv trailer

Search results

  1. Results From The WOW.Com Content Network
  2. Coaming - Wikipedia

    en.wikipedia.org/wiki/Coaming

    Hatch coaming (bottom right) on a bugeye. Coaming is any vertical surface on a ship designed to deflect or prevent entry of water. It usually consists of a raised section of deck plating around an opening, such as a cargo hatch. Coamings also provide a frame onto which to fit a hatch cover.

  3. Hold (compartment) - Wikipedia

    en.wikipedia.org/wiki/Hold_(compartment)

    Most cargo hatches have a coaming, a raised edge around the hatch, to help keep out water. The term batten down the hatches is used prepare the ship for bad weather. This may included securing cargo hatch covers with wooden battens, to prevent water from entering from any angle. The term cargo hatch can also be a used for any deck opening ...

  4. Butterworth cover - Wikipedia

    en.wikipedia.org/wiki/Butterworth_Cover

    Butterworth hatches are not the main access hatches, but are the servicing hatches, and are generally closed with a metal cover plate with a gasket that is fastened to the deck by a number of bolts which stick up from the deck. Holes on the edges of the plate fit over these bolts and the cover is fastened down with nuts or dogs.

  5. Compartment (ship) - Wikipedia

    en.wikipedia.org/wiki/Compartment_(ship)

    A watertight hatch with the door dogs clearly visible Three types of doors are commonly used between compartments. A closed watertight door is structurally capable of withstanding the same pressures as the watertight bulkheads they penetrate, although such doors require frequent maintenance to maintain effective seals, and must, of course, be ...

  6. Open hatch bulk carrier - Wikipedia

    en.wikipedia.org/wiki/Open_hatch_bulk_carrier

    The open hatch bulk carrier, often referred to as OHBC or conbulker, is designed to offer direct access to the hold through cargo hatches which extend the full width of the vessel. As a result, large cargo units can be lowered into place. If it is possible, the holds or hatches are designed around standard cargo unit sizes.

  7. Conning tower - Wikipedia

    en.wikipedia.org/wiki/Conning_tower

    As larger and larger submarines were made, and eventually fitted with periscopes, this protrusion grew into a small pressure-hull of its own, typically connected to the control room inside the boat's main pressure-hull via a watertight hatch to mitigate the risk of flooding if the viewports or periscopes were damaged. Thus, the conning tower ...