Search results
Results From The WOW.Com Content Network
Steel arm that converts the reciprocating motion of the piston into a rotary motion of the driving wheels. The connection between piston and main rod is a crosshead, which slides on a horizontal bar behind the cylinder. [2] [5] [3]: 55 Piston rod Connects the piston to the cross-head. [2] [3]: 61 Piston
From Wikipedia, the free encyclopedia. Redirect page
The follower arm, which is the link that connects the crank arm to the slider, connects to a pin in the center of sliding object. This pin is considered to be on the linear movement axis. Therefore, to be considered an in-line crank slider, the pivot point of the crank arm must be in-line with this pin point.
A crank is an arm attached at a right angle to a rotating shaft by which circular motion is imparted to or received from the shaft. When combined with a connecting rod, it can be used to convert circular motion into reciprocating motion, or vice versa. The arm may be a bent portion of the shaft, or a separate arm or disk attached to it.
The slider-crank linkage (RRRP) is one type of arrangement such that one link is a crank, which is then connected to a slider by a connecting rod. The inverted slider-crank is another type of arrangement such that there are two cranks with a slider acting as the coupler.
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942 The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3]
Some OHC engines employ short rocker arms, also known as finger followers, [2] in which the cam lobe pushes downward on the back of the rocker arm to open the valve. In such a configuration one end of the follower is anchored (pivoting in place on a roller bearing), rather than having its fulcrum in the center like standard rocker arms.
Many two-stroke engines use a crankcase-compression design, where a partial vacuum draws the fuel/air mixture into the engine as the piston moves upwards. Then as the piston travels downward, the inlet port is uncovered and the compressed fuel/air mixture is pushed from the crankcase into the combustion chamber.