Search results
Results From The WOW.Com Content Network
Articles relating to ignition systems, which generate a spark or heat an electrode to a high temperature to ignite a fuel-air mixture. Subcategories This category has only the following subcategory.
Auto reignition lowers the risk of gas leaks: if a flame goes out during operation, for example, from vibration or a gust of wind; due to misoperation—a user might not understand the "light" position must be maintained for about 0.5 to 2 seconds before turning the burner knob on fully.
An ignition magneto (also called a high-tension magneto) is an older type of ignition system used in spark-ignition engines (such as petrol engines). It uses a magneto and a transformer to make pulses of high voltage for the spark plugs. The older term "high-tension" means "high-voltage".
On early designs, ignition timing was adjusted by adjusting the position of the red-hot spot on the tube - the burner is moved towards the far end to retard ignition, and towards the base to advance. Most later styles used a fixed burner and varied tube lengths to change ignition timing.
A trembler coil, buzz coil or vibrator coil is a type of high-voltage ignition coil used in the ignition system of early automobiles, most notably the Benz Patent-Motorwagen and the Ford Model T. [2] Its distinguishing feature is a vibrating magnetically-activated contact called a trembler or interrupter , [ 3 ] [ 1 ] which breaks the primary ...
Trionic is an engine management system developed by Saab Automobile. It consists of an engine control unit (ECU) that controls 3 engine aspects: Ignition timing; Fuel injection; Acts as a boost controller. The numerical prefix 'tri-' yes (Tri being three) in Trionic. 'Ion' comes from the fact that it uses ion current, measured by the spark ...
Hot-wiring is the process of bypassing a motor vehicle's ignition switch and thus starting it without the key.It is often utilized during a vehicle theft. [1] However, a legitimate vehicle owner who has lost a vehicle key or starting a vehicle with inoperable ignition switch (e.g. in run-down old cars) may also use this process.
The ignition system of an internal combustion engines depends on the type of engine and the fuel used. Petrol engines are typically ignited by a precisely timed spark, and diesel engines by compression heating. Historically, outside flame and hot-tube systems were used, see hot bulb engine.