When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Standing wave ratio - Wikipedia

    en.wikipedia.org/wiki/Standing_wave_ratio

    Voltage standing wave ratio (VSWR) (pronounced "vizwar" [1] [2]) is the ratio of maximum to minimum voltage on a transmission line . For example, a VSWR of 1.2 means a peak voltage 1.2 times the minimum voltage along that line, if the line is at least one half wavelength long.

  3. Scattering parameters - Wikipedia

    en.wikipedia.org/wiki/Scattering_parameters

    The voltage standing wave ratio (VSWR) at a port, represented by the lower case 's', is a similar measure of port match to return loss but is a scalar linear quantity, the ratio of the standing wave maximum voltage to the standing wave minimum voltage.

  4. Reflections of signals on conducting lines - Wikipedia

    en.wikipedia.org/wiki/Reflections_of_signals_on...

    A time-domain reflectometer; an instrument used to locate the position of faults on lines from the time taken for a reflected wave to return from the discontinuity.. A signal travelling along an electrical transmission line will be partly, or wholly, reflected back in the opposite direction when the travelling signal encounters a discontinuity in the characteristic impedance of the line, or if ...

  5. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  6. Attenuator (electronics) - Wikipedia

    en.wikipedia.org/wiki/Attenuator_(electronics)

    Nominal impedance, for example 50 ohm; Frequency bandwidth, for example DC-18 GHz; Power dissipation depends on mass and surface area of resistance material as well as possible additional cooling fins. SWR is the standing wave ratio for input and output ports; Accuracy; Repeatability

  7. Signal reflection - Wikipedia

    en.wikipedia.org/wiki/Signal_reflection

    In radio frequency (RF) practice this is often measured in a dimensionless ratio known as voltage standing wave ratio (VSWR) with a VSWR bridge. The ratio of energy bounced back depends on the impedance mismatch. Mathematically, it is defined using the reflection coefficient. [2]

  8. Waveguide - Wikipedia

    en.wikipedia.org/wiki/Waveguide

    An impedance mismatch can be also quantified with the standing wave ratio (SWR or VSWR for voltage), which is connected to the impedance ratio and reflection coefficient by: = | | | | = + | | | |, where | | / are the minimum and maximum values of the voltage absolute value, and the VSWR is the voltage standing wave ratio, which value of 1 ...

  9. Antenna (radio) - Wikipedia

    en.wikipedia.org/wiki/Antenna_(radio)

    Electronic symbol for an antenna. The words antenna and aerial are used interchangeably. Occasionally the equivalent term "aerial" is used to specifically mean an elevated horizontal wire antenna. The origin of the word antenna relative to wireless apparatus is attributed to Italian radio pioneer Guglielmo Marconi.