Search results
Results From The WOW.Com Content Network
The cavity magnetron is a high-power vacuum tube used in early radar systems and subsequently in microwave ovens and in linear particle accelerators. A cavity magnetron generates microwaves using the interaction of a stream of electrons with a magnetic field , while moving past a series of cavity resonators , which are small, open cavities in a ...
Microwave signals are normally limited to the line of sight, so long-distance transmission using these signals requires a series of repeaters forming a microwave relay network. It is possible to use microwave signals in over-the-horizon communications using tropospheric scatter , but such systems are expensive and generally used only in ...
TD-2 was a microwave relay system developed by Bell Labs and used by AT&T to build a cross-country network of repeaters for telephone and television transmission. The same system was also used to build the Canadian Trans-Canada Skyway system by Bell Canada , and later, many other companies in many countries to build similar networks for both ...
The simplest klystron tube is the two-cavity klystron. In this tube there are two microwave cavity resonators, the "catcher" and the "buncher". When used as an amplifier, the weak microwave signal to be amplified is applied to the buncher cavity through a coaxial cable or waveguide, and the amplified signal is extracted from the catcher cavity.
A microwave cavity or radio frequency cavity (RF cavity) is a special type of resonator, consisting of a closed (or largely closed) metal structure that confines electromagnetic fields in the microwave or RF region of the spectrum. The structure is either hollow or filled with dielectric material. The microwaves bounce back and forth between ...
Like all compliance testing, it is important that the test equipment, including the test chamber or site and any software used, be properly calibrated and maintained. Typically, a given run of tests for a particular piece of equipment will require an EMC test plan and a follow-up test report. The full test program may require the production of ...
A horn antenna or microwave horn is an antenna that consists of a flaring metal waveguide shaped like a horn to direct radio waves in a beam. Horns are widely used as antennas at UHF and microwave frequencies, above 300 MHz. [ 1 ]
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...