Search results
Results From The WOW.Com Content Network
Digital I/O with PWM (pins) Analog input (pins) Analog output pins Arduino Nano ESP32 [3] u-blox NORA-W106 (ESP32-S3) up to 240 MHz minimal 45 mm × 18 mm [ 1.8 in × 0.7 in ] USB-C 3.3 V 16MB 384 512 14 5 8 Arduino Uno WiFi rev 2 [4] ATMEGA4809, NINA-W132 Wi-Fi module from u-blox, ECC608 crypto device 16 MHz Arduino / Genuino
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
NodeMCU is an open source firmware for which open source prototyping board designs are available. The name "NodeMCU" combines "node" and "MCU" (micro-controller unit). [8] Strictly speaking, the term "NodeMCU" refers to the firmware rather than the associated development kits. [citation needed]
Input and output voltages are usually, but not always, limited to the supply voltage of the device with the GPIOs, and may be damaged by greater voltages. A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions.
Digital I/O with PWM (pins) Analog input (pins) Analog output pins Arduino / Genuino MKR1000 Arduino Yes ATSAMW25 (made of SAMD21 Cortex-M0+ 32 bit ARM MCU, WINC1500 2.4 GHz 802.11 b/g/n Wi-Fi, and ECC508 crypto device ) 48 MHz minimal 61.5 mm x 25 mm USB 3.3 V 256 No 32 8 12 7 1 Announced: April 2, 2016 Arduino 101 [1] Genuino 101. Arduino Yes
ATtiny (also known as TinyAVR) is a subfamily of the popular 8-bit AVR microcontrollers, which typically has fewer features, fewer I/O pins, and less memory than other AVR series chips. The first members of this family were released in 1999 by Atmel (later acquired by Microchip Technology in 2016).
A drop-in compatible device is a device which may be swapped with another without need to make compensating alterations to the system the device was a part of. The device will have the same functions available on the same pins, and will be electrically and thermally compatible. Such devices may not be an exact match to the devices they can replace.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...