When.com Web Search

  1. Ads

    related to: faucet flow rate standards

Search results

  1. Results From The WOW.Com Content Network
  2. Low-flow fixtures - Wikipedia

    en.wikipedia.org/wiki/Low-flow_fixtures

    Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [10] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

  3. EPA WaterSense - Wikipedia

    en.wikipedia.org/wiki/EPA_WaterSense

    Using the efficiency standards established by EPACT92 as a baseline, the EPA instituted the following flow-rate guidelines for WaterSense: toilets must be manufactured with a maximum flush volume of 1.28 gpf; showerheads must have a maximum flow-rate of 2.0 gpm at 80 psi; and bathroom faucets must be manufactured with a low-flow volume rate of ...

  4. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    In plumbing, a Fixture Unit (FU) or Drain Fixture Unit (DFU) is "a unit of measure, based on the rate of discharge, time of operation and frequency of use of a fixture, that expresses the hydraulic load imposed by that fixture on the sanitary plumbing installation". [1] A Fixture Unit is not a flow rate unit but a design factor.

  5. Faucet aerator - Wikipedia

    en.wikipedia.org/wiki/Faucet_aerator

    A faucet aerator can be classified on the basis of its flow rate and the type of water stream (aerated, non-aerated, spray) it produces. In general, standard-sized aerators are available with female (M22x1) or male threading (M24x1). Bathtub spouts often have a bigger diameter with a male M28x1 thread.

  6. Uniform Plumbing Code - Wikipedia

    en.wikipedia.org/wiki/Uniform_Plumbing_Code

    Designated as an American National Standard, the Uniform Plumbing Code (UPC) is a model code developed by the International Association of Plumbing and Mechanical Officials to govern the installation and inspection of plumbing systems as a means of promoting the public's health, safety and welfare.

  7. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Its rate is independent of the viscosity or temperature of the fluid or gas in the pipe, and depends only weakly on the supply pressure, so that flow rate is stable at a given setting. At intermediate flow settings the pressure at the valve restriction drops nearly to zero from the Venturi effect ; in water taps, this causes the water to boil ...