Search results
Results From The WOW.Com Content Network
Since the control signals for a serial port can be driven by any digital signal, some applications used the control lines of a serial port to monitor external devices, without exchanging serial data. A common commercial application of this principle was for some models of uninterruptible power supply which used the control lines to signal loss ...
In the real world some low-end devices may only support a subset of these 488.2 commands, or may even accept the commands but not perform any operation. A user should check the official programmers manual for each device before assuming all of these 488.2 commands are supported.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
A software-based virtual serial port presents one or more virtual serial port identifiers on a PC which other applications can see and interact with as if they were real hardware ports, but the data sent and received to these virtual devices is handled by software that manipulates the transmitted and received data to grant greater functionality.
"Y" cables may be used to allow using another serial port to monitor all traffic on one direction. A serial line analyzer is a device similar to a logic analyzer but specialized for RS-232's voltage levels, connectors, and, where used, clock signals; it collects, stores, and displays the data and control signals, allowing developers to view ...
The term "Serial Communications Interface" (SCI) was first used at Motorola around 1975 to refer to their start-stop asynchronous serial interface device, which others were calling a UART. Zilog manufactured a number of Serial Communication Controllers or SCCs.
A typical EEPROM serial protocol consists of three phases: OP-code phase, address phase and data phase. The OP-code is usually the first 8 bits input to the serial input pin of the EEPROM device (or with most I²C devices, is implicit); followed by 8 to 24 bits of addressing, depending on the depth of the device, then the read or write data.
This is a concern if the main uses general-purpose input/output (GPIO) pins (which may default to an undefined state) for CS and if the main uses separate software libraries to initialize each device. One solution is to configure all GPIOs used for CS to output a high voltage for all subs before running initialization code from any of those ...