Search results
Results From The WOW.Com Content Network
When scaling a vector graphic image, the graphic primitives that make up the image can be scaled using geometric transformations with no loss of image quality. When scaling a raster graphics image, a new image with a higher or lower number of pixels must be generated. In the case of decreasing the pixel number (scaling down), this usually ...
PixelSense is designed primarily for use by commercial customers to use in public settings. People interact with the product using direct touch interactions and by placing objects on the screen. Objects of a specific size and shape, or with tag patterns, can be uniquely identified to initiate a preprogrammed response by the computer.
Next, the rotated image is created with a nearest-neighbor scaling and rotation algorithm that simultaneously shrinks the big image back to its original size and rotates the image. Finally, overlooked single-pixel details are (optionally) restored if the corresponding pixel in the source image is different and the destination pixel has three ...
A megapixel (MP) is a million pixels; the term is used not only for the number of pixels in an image but also to express the number of image sensor elements of digital cameras or the number of display elements of digital displays. For example, a camera that makes a 2048 × 1536 pixel image (3,145,728 finished image pixels) typically uses a few ...
An image that is 2048 pixels in width and 1536 pixels in height has a total of 2048×1536 = 3,145,728 pixels or 3.1 megapixels. One could refer to it as 2048 by 1536 or a 3.1-megapixel image. The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 ...
The fill factor of an image sensor array is the ratio of a pixel's light sensitive area to its total area. For pixels without microlenses, the fill factor is the ratio of photodiode area to total pixel area, [1] but the use of microlenses increases the effective fill factor, often to nearly 100%, by converging light from the whole pixel area into the photodiode.
Pixels were arrayed in a two-dimensional structure, with an access enable wire shared by pixels in the same row, and output wire shared by column. At the end of each column was a transistor. Passive-pixel sensors suffered from many limitations, such as high noise, slow readout, and lack of scalability.
The size of a screen is usually described by the length of its diagonal, which is the distance between opposite corners, typically measured in inches. It is also sometimes called the physical image size to distinguish it from the "logical image size," which describes a screen's display resolution and is measured in pixels. [1] [2]