Search results
Results From The WOW.Com Content Network
The term can also be used as part of an action; to "perform I/O" is to perform an input or output operation. I/O devices are the pieces of hardware used by a human (or other system) to communicate with a computer. For instance, a keyboard or computer mouse is an input device for a computer, while monitors and printers are output devices.
A general-purpose input/output (GPIO) is an uncommitted digital signal pin on an integrated circuit or electronic circuit (e.g. MCUs/MPUs) board which may be used as an input or output, or both, and is controllable by software. GPIOs have no predefined purpose and are unused by default.
Outputs from the digital controller are functions of current and past input samples, as well as past output samples - this can be implemented by storing relevant values of input and output in registers. The output can then be formed by a weighted sum of these stored values. The programs can take numerous forms and perform many functions
SDIO may refer to: . Secure Digital Input Output, a type of Secure Digital card interface.It can be used as an interface for input or output devices. Strategic Defense Initiative Organization, an organization set up to oversee the Strategic Defense Initiative; now known as the Missile Defense Agency.
Input devices can be categorized based on: modality of output (e.g., mechanical motion, audio, visual, etc.) whether the output is discrete (e.g., pressing of key) or continuous (e.g., a mouse's position, though digitized into a discrete quantity, is fast enough to be considered continuous)
The input signal and the DAC both go to a comparator. The comparator controls the counter. The circuit uses negative feedback from the comparator to adjust the counter until the DAC's output matches the input signal and number is read from the counter. Delta converters have very wide ranges and high resolution, but the conversion time is ...
The ability of a DAC's analog output to move only in the direction that the digital input moves (i.e., if the input increases, the output doesn't dip before asserting the correct output.) This characteristic is very important for DACs used as a low-frequency signal source or as a digitally programmable trim element. [citation needed]
Most digital systems divide into combinational and sequential systems. The output of a combinational system depends only on the present inputs. However, a sequential system has some of its outputs fed back as inputs, so its output may depend on past inputs in addition to present inputs, to produce a sequence of operations.